Monster 696 abs rough running and qr fuel connectors

Hello, the bike is a 2013 model with just 8500 miles on the clock. I’ve had a running issue, at approximately 4000 rpm a massive flat spot developed. This then developed into a rough idle and stalling. After some research the most likely problem seemed to be leaking vacuum hoses. Bodywork, tank and air box removed and indeed one vacuum pipe split. Replaced with better quality pipes. While everything was apart I decided to change the fuel filter. Pump removed and the remains of a small pipe was found. New pump and filter installed. Bike starts and idles fine, revs up cleanly etc in the garage. The issue now is the fuel lines popped off when I first put it back together. So I’ve done a temporary fix just to get the bike running. I’ve not taken out on the road. Temporarily fix will be in the photo to follow. So, my question, is there a better alternative to the standard qr connections. Not confident in them at all. Apologies for the long winded post.

Have you spoken to the likes of MotoRapido or others who race Ducatis as the tank is on and off multiple times over a weekend or even during testing to see what they recommend? I’d suggest using the standard fittings as they lasted a good few years before you messed with them, however, I fully understand your hesitation. I had a similar issue with a Triumph Street Triple, but new standard fittings were fine

Thanks for the reply. Having had more time to have a think and do some more research I think you’re probably right. This is the first bike I’ve had with QR fuel pipes so a bit of a learning curve but I think 2 new connections will be the way to go. I think the issue was exaggerated by fact the fuel lines were disconnected and reconnected a number of times due to the running issue and they don’t appear to be the most robust. Thanks again.

1 Like